Hammer mills are the generally used machine to obtain smaller particles in the feed industry. Hammer mills consist of 3 parts:
- Feeder with electronic controller
- Magnetic seperator, aspiration air inlet and drawer head
- Hammer mill and motor frame |
| |
|
|
Screw feeder with electronic control unit |
|
Permanent magnet |
|
Aspiration air inlet |
|
Drawer for discharge of the high density material |
|
From 5 to 60 tons/hours capacities |
|
Two directions of rotations |
|
Rotor has been balanced under maximum working speed |
|
Particle size up to 60 mm. edge lenght |
|
Bulk density 0.2 to 0.8 kg/dm3 |
|
Electropneumatically controlled pivoted deflection plate |
|
Low noise 90-93 dba under nominal load |
 |
Easily changeable screens within one minute by quick span lock |
|
Interlock preventing opening of doors(when motor is running) |
|
Mechanical break system to stop the rotor in a few seconds. |
|
Two bearing suspension |
|
Hammers and rods hardfaced for long life |
